Beam Clamp Structural Steel Corner Fixing
- Used as corner fixings for perimeter wire rope netting frameworks
- Secure to the flanges of structural steel members such as 'H' or 'C' section beams and columns
- Five variants in the range will fit a flanges up to 20mm, 28mm, 50mm & 75mm thick
- Available in galvanised or stainless steel
- For thicker flanges over 75mm use Lindapter clamps
Specification
We offer this range of clamps in either plated ductile steel or grade 304 stainless steel as follows:
- NF159 - Plated ductile steel for flanges 0mm - 20mm thick
- NF160 - Stainless steel (304) for flanges 0mm - 20mm thick.
- NF336 - Plated ductile steel for flanges 0mm - 28mm thick.
- NF332 - Stainless steel (304) for flanges 20mm - 50mm thick
- NF333 - Stainless steel (304) for flanges 45mm - 75mm thick.
Usage
Netting corner fixings are the foundation of any netting system as they are designed to take all of the tensile loads delivered into the netting perimeter's wire rope framework by the the barrel strainers, additional wind-loadings and loads imposed by snow, ice or leaves.
Use the Beam Clamp to anchor runs of wire rope at each end of your bird control netting perimeter framework and at 10m linear intervals around the perimeter in order to strain from.
Your perimeter wire rope framework should start, finish and be tensioned from these clamps.
.jpg)
.jpg)
.jpg)
