• For the Gull Grid Parallel Wire Roof Protection System
• Run parallel wires at 400mm centres
• Minimum height from ground/roof 500mm
• Gulls will not be able to land between the wires
• Use netting perimeter wire rope and fixings
• Secured to perimeter using 2.5mm ferrules

Use the same mounts and perimeter straining wire / fixings as for a bird control net installation, but then fit a series of parallel wires using this 1.2mm Orange Wire Rope

The orange PVC coating provides extra visibility to gulls and increases the overall diameter to 1.5mm

Run parallel wires across the roof at 400mm centres and secure to perimeter wire rope with 2.5mm Copper Ferrules.

During perimeter wire rope installation slide enough Ferrules on to the perimeter straining wire before terminating and tensioning. However if you run short of ferrules then use Wire Rope Grips.

Allows maintenance staff to walk between or over the wires as it is installed lower, reducing the visual impact.

Parallel wires do not need to be tensioned and should ideally sag slightly to move in the wind for extra deterrence.

For the Gull Grid Parallel Wire Roof Protection System.

Alternative to installing a roof net.

Uses:

• Flat Roofs
• Overhead on outdoor eating areas
• Industrial shallow pitched roofs