• Stainless steel ridge bracket designed to facilitate post and wire installations along ridge lines
• Supports three parallel runs of wire along roof ridge
• Prevents pest birds from fouling ridges
• 4mm single head posts, 110mm for pigeons and 180mm for gulls
• Can be glued in positioned (preferred)

Stainless steel ridge bracket designed to carry three parallel runs of wire along roof ridges to keep pigeons from landing on the ridge tiles and fouling them

The bracket base is designed to fit round triangular ridge tiles

The posts are each 110mm or 180mm tall X 4mm in diameter, with eyelets stamped in their tops as per the normal bird posts.

For Use in protecting roof ridges from perching birds and preventing the roof from being affected by bird droppings.

Use as a low-profile alternative to bird spikes on low pressure bird infestations.

Brackets can be fixed to ridges in three different ways.

• Bonding, preferred method, strongest

The bonding method is ideal for fragile tiles that do not take kindly to drilling. Ensure ridge tile is clean and dry and has been primed with adhesive prior to fitting bracket. Ensure that the bracket has been de-greased on the underside using surface activator. Leave for 24 hours to fully cure before wiring.

1. Install brackets at no more than 1.5m centres

2. Install counter tension wires and screw pin anchor at each end of the ridge line without springs.

3. Run wires, stopping and starting at each bracket with a crimp and spring (do not run wires through the bracket)

4. Ensure wires are under load from the springs, but do not over-stretch the spring, leave some spring travel for when birds attempt to land.