• Virtually odourless insecticide for the control of flying and crawling insects
• Controllable residual activity using pioneering FFAST™ technology
• Accepted for use in certified organic premises
• Low volume: 100ml treats 3000m³
• Use neat for ULV space treatment or dilute for coarse spray or forgging

Aquapy is a water-based formulation ideal for space treatments against flies, mosquitoes, moths, tobacco beetles on the wing and other stored product insects.

It is a virtually odourless, non flammable, water based insecticide which contains natural pyrethrum, synergised with piperonyl butoxide. This combination gives it the flexibility in where and how it can be used; ready-to-use for application as an ultra low volume aerosol or can be diluted with water for application as a mist, thermal fog or surface spray.

AquaPy is also accepted for use in certified organic premises and has the ability to be applied as a space spray (ULV aerosol, Mist/Thermal Fog) or as surface spray depending on the situation and target pest.

IMPORTANT INFORMATION

Contains 30 g / litre of pyrethrins synergised with 150 g / litre piperonyl butoxide.

AquaPy contains Pyrethrins including cinerins (AOAC) 3.00% w/w (30 g/L) synergised with piperonyl butoxide. (HSE 5799, PCS 93571).

DIRECTIONS FOR USE

SHAKE CONTAINER THOROUGHLY BEFORE DISPENSING AQUAPY.

As a Space Spray Indoors:

Close doors and windows and shut off ventilation systems before spraying and for at least 30 minutes after treatment. Distribute spray evenly throughout the area. Treatments should be timed to coincide with the time of maximum flight activity for the target insect. For Tobacco Beetles this will typically be in the late afternoon and evening.

Direct the spray into identified insect harbourages. Spray as frequently as the situation demands. Treatment at weekly intervals is recommended. More frequent applications may be necessary for heavy infestations.

As a Space Spray Outdoors:

In general the dose rate for large areas should be acceptable (see table), but if only small areas are being treated the dose rate may have to be increased. The best conditions for outdoor spraying occur in the early morning or late afternoon and evening when conditions are most likely to be still.

As a Surface Spray:

As a direct contact spray apply at a rate sufficient to dampen the insects present on the fabric of warehouses, granaries, mills, bakeries and similar situations, or to insects on the surfaces of bags and cases containing stored food products. Special attention should be paid to cracks and crevices and other insect harbourages. Spray as frequently as the situation demands. Residuality will depend on the rate used and the environmental conditions (surface type, cleanliness, moisture, temperature, etc).

Solid Waste Management:

In solid waste management programmes the use of AquaPy should be integrated with good management practices e.g. regular infilling and compaction of refuse to a depth of at least 225 mm. New tip surfaces should be sprayed as they are created. Treatments should be repeated as necessary.

For Wasp Nests:

Apply liberally and directly to the nest or to entrance holes of concealed nests until the nest is saturated. Treatments should only be carried out at dusk or other times when wasp activity around the nest is minimal.

USE BIOCIDES SAFELY.

ALWAYS READ THE LABEL AND PRODUCT INFORMATION BEFORE USE.

PAY ATTENTION TO THE RISK INDICATIONS AND FOLLOW THE SAFETY PRECAUTIONS ON THE LABEL.

Product Label

MSDS